R315-265-56. Contingency Plan and Emergency Procedures --Emergency Procedures

  (a) Whenever there is an imminent or actual emergency situation, the emergency coordinator, or his designee when the emergency coordinator is on call, shall immediately:

  (1) Activate internal facility alarms or communication systems, where applicable, to notify all facility personnel; and

  (2) Notify appropriate State or local agencies with designated response roles if their help is needed.

  (b) Whenever there is a release, fire, or explosion, the emergency coordinator shall immediately identify the character, exact source, amount, and areal extent of any released materials. He may do this by observation or review of facility records or manifests and, if necessary, by chemical analysis.

  (c) Concurrently, the emergency coordinator shall assess possible hazards to human health or the environment that may result from the release, fire, or explosion. This assessment shall consider both direct and indirect effects of the release, fire, or explosion, for example, the effects of any toxic, irritating, or asphyxiating gases that are generated, or the effects of any hazardous surface water run-offs from water or chemical agents used to control fire and heat-induced explosions.

  (d) If the emergency coordinator determines that the facility has had a release, fire, or explosion which could threaten human health, or the environment, outside the facility, he shall report his findings as follows:

  (1) If his assessment indicates that evacuation of local areas may be advisable, he shall immediately notify appropriate local authorities. He shall be available to help appropriate officials decide whether local areas should be evacuated; and

  (2) He shall immediately notify the Utah Department of Environmental Quality as specified in Section R315-263-30 and either the government official designated as the on-scene coordinator for that geographical area, or the National Response Center, using their 24-hour toll free number 800/424-8802. The report shall include:

  (i) Name and telephone number of reporter;

  (ii) Name and address of facility;

  (iii) Time and type of incident, for example, release, fire;

  (iv) Name and quantity of material(s) involved, to the extent known;

  (v) The extent of injuries, if any; and

  (vi) The possible hazards to human health, or the environment, outside the facility.

  (e) During an emergency, the emergency coordinator shall take all reasonable measures necessary to ensure that fires, explosions, and releases do not occur, recur, or spread to other hazardous waste at the facility. These measures shall include, where applicable, stopping processes and operations, collecting and containing released waste, and removing or isolating containers.

  (f) If the facility stops operations in response to a fire, explosion or release, the emergency coordinator shall monitor for leaks, pressure buildup, gas generation, or ruptures in valves, pipes, or other equipment, wherever this is appropriate.

  (g) Immediately after an emergency, the emergency coordinator shall provide for treating, storing, or disposing of recovered waste, contaminated soil or surface water, or any other material that results from a release, fire, or explosion at the facility.

  Comment: Unless the owner or operator can demonstrate, in accordance with Subsections R315-261-3(c) or (d), that the recovered material is not a hazardous waste, the owner or operator becomes a generator of hazardous waste and shall manage it in accordance with all applicable requirements of Rules R315-262, R315-263, and R315-265.

  (h) The emergency coordinator shall ensure that, in the affected area(s) of the facility:

  (1) No waste that may be incompatible with the released material is treated, stored, or disposed of until cleanup procedures are completed; and

  (2) All emergency equipment listed in the contingency plan is cleaned and fit for its intended use before operations are resumed.

  (i) The owner or operator shall note in the operating record the time, date, and details of any incident that requires implementing the contingency plan. Within 15 days after the incident, he shall submit a written report on the incident to the Director. The report shall include:

  (1) Name, address, and telephone number of the owner or operator;

  (2) Name, address, and telephone number of the facility;

  (3) Date, time, and type of incident, for example, fire, explosion;

  (4) Name and quantity of material(s) involved;

  (5) The extent of injuries, if any;

  (6) An assessment of actual or potential hazards to human health or the environment, where this is applicable; and

  (7) Estimated quantity and disposition of recovered material that resulted from the incident.